Goodwood Audio The Bass Interfacer Bass Pedal

The Bass Interfacer is everything you need to run independent, mutable, clean and effects lines.

Splitting your bass into two lines allows you to have the full spectrum of your clean running in parallel with your effected signal gives you the texture of the overdrive or fuzz while still retaining the bottom end you you’ve worked so hard to get. Run them down one line in parallel, or two independent (Clean and FX) lines.

The Bass Interfacer comes with a Clean Mute and an FX Mute which correspond to your clean return and FX return jacks.

• Clean Mute – This foot switch will mute or unmute whatever effects you have placed in the clean send and return of The Bass Interfacer. This allows you to run only the pedals in your FX send and return or hit both footswitches to use as a master mute.
• FX Mute – This footswitch will mute or unmute whatever effects you have placed in the FX send and return of The Bass Interfacer. This allows you to run only the pedals in your Clean send and return or hit both foot switches to use as a master mute.

Bass Summing - The Bass Interfacer allows you to take both your FX line and your Clean line and send them to the clean output. And you can still maintain individual control over the Clean and the FX lines. Mute Clean or FX individually, keep them both on or both off.

Input - The Bass Interfacer comes with a buffered input. This means before your bass sees the first pedal on your board you are sending a high impedance signal to your pedals, preserving your tone. The Bass Interfacer also comes with an always-on tuner out.

Parallel Effects - The downside to series pedal boards (running one effect into another until you hit your amp/DI) is fuzz and overdrives can cut your low end. The Bass Interfacer solves this problem by layering your overdrive/fuzz effects in parallel with your clean effects.

Phase Correction - Whenever you use more than one amp or DI you need to make sure they are in phase with each other. Certain effects will invert phase 180 degrees. If two or more lines are not in phase with each other they will start to cancel each other out. Now you can put your clean effects and overdrive effects back in phase with each other and keep your bass tone intact.

Dimensions – 115mm L x 75mm W x 67mm H (including all jacks, switches and push buttons).